Case Study
BMS FCT / EOL / Burn-In Automated Test System
This case addresses BMS production test requirements covering FCT, EOL, burn-in, CAN/LIN communication, ADC calibration, DI/DO, Daisy Chain and test data traceability. The project setup runs burn-in on 24 units in parallel.
BMS automated test system architecture diagram
Test SoftwareInstrumentationFixtureDUTTraceability
Software, instrumentation, fixture, DUT and production data integration.Project Overview
Automated test system case for BMS functional test, EOL, burn-in, communication, ADC calibration and production traceability.
Testing Requirements
- Cover BMS PCBA and module-level functional tests.
- Support CAN / LIN communication and Daisy Chain related tests.
- Perform ADC calibration, DI/DO verification and burn-in data logging.
- Support the 24-unit parallel burn-in project configuration.
System Architecture
Test SoftwareLabVIEW Test ExecutiveRS485 Custom Control HardwareFixture / InterfaceBMS DUTReport / Traceability
Key Test Items
CANLINADC CalibrationDI / DODaisy ChainFCTEOLBurn-InParallel Test
Engineering Challenges
- The test scope includes function, communication, calibration and long-duration burn-in.
- Parallel test configuration requires coordinated channel, status and data management.
- Custom control hardware must work reliably with the test software.
Implementation
- LabVIEW test software organizes test flow, channel control, data acquisition and report output.
- RS485 custom control hardware manages fixture, channel and peripheral signal control.
- Communication, calibration, functional test and burn-in are integrated into one test architecture.
Engineering Outcome
- A maintainable automated test system was built for BMS production testing.
- The project example supports a 24-unit parallel burn-in configuration.
- Test data can support production traceability and engineering analysis.
Related Solutions
Related Engineering Capabilities
Test EngineeringHardware EngineeringSoftware EngineeringCommunication & ProtocolCalibrationProduction Integration
View Engineering Capabilities Discuss a Similar Test Requirement
If your DUT, coverage, cycle time or data requirements are similar, we can start from interfaces and test strategy to evaluate the architecture.
Contact onTAP