Case Study
Antenna Amplifier Multi-Board RF Functional Test System
The NI LabVIEW system runs parallel RF tests on panels of 12–24 boards, covering FM, AM, amplifier gain, modulated frequency and signal power.
Antenna amplifier multi-board RF test architecture diagram
Test SoftwareInstrumentationFixtureDUTTraceability
Software, instrumentation, fixture, DUT and production data integration.Project Overview
Multi-board panel RF functional test case for antenna amplifiers, covering FM, AM, gain, modulated frequency and signal power.
Testing Requirements
- Support FM test and AM test.
- Support 12–24 multi-board panel test in the project configuration.
- Verify amplifier gain, modulated frequency and signal power.
System Architecture
RF ResourcesSwitch / RoutingDUT1 / DUT2 / DUTnPanel FixtureTest SoftwareResult
Key Test Items
FM TestAM TestProject Configuration: 12–24 boards per panelAmplifier GainModulated FrequencySignal Power
Engineering Challenges
- Multi-board parallel testing requires RF resource sharing and multi-channel fixture support.
- Gain, frequency and signal power measurements need one coordinated test sequence.
Implementation
- NI LabVIEW organizes RF test flow and result recording.
- Panel fixture supports multi-board connection and test switching.
- Test logic is designed around RF resource sharing, gain measurement, frequency verification and signal power measurement.
Engineering Outcome
- A parallel RF functional test system was built for antenna amplifier panels.
- The project configuration supports 12–24 boards per panel.
Related Solutions
Related Engineering Capabilities
RFParallel TestFixtureInstrumentation
View Engineering Capabilities Discuss a Similar Test Requirement
If your DUT, coverage, cycle time or data requirements are similar, we can start from interfaces and test strategy to evaluate the architecture.
Contact onTAP